Guardian Body Armour
Anti-rape Devices and Chastity Belts for Males
MB/100 Belt Set
The standard male chastity belt follows a traditional Florentine design. This consists of a waistband (1.25" wide and 0.64" thick) with an attached crotch guard which is closed and locked at the centre of the waist. The crotch guard incorporates a penis sheath that, unlike other chastity belt manufacturers, is made to the individual's precise measurements. This is a separate component into which the penis is inserted, it is then engaged internally into the crotch guard, which is then locked to the waistband. The sheath is adjusted to its correct position externally and then secured with a second locking system. In this belt the penis is held pointing downwards and backwards between the legs, which prevents an erection but allows the wearer to urinate without any problem - except that he has to sit like a female. Once the sheath is locked into position the penis cannot be handled. The crotch guard is shaped and contoured to fit the genital area and stops just short of the anus, where it terminates in two flat-section stainless steel chains. To permit defecation these form a "Y" configuration going over the buttocks to the waist band, where they are riveted.
The belt is 100% effective in preventing intercourse and masturbation. Both locks on this belt are keyed alike unless specifically requested otherwise.
Manufactured from medical grade stainless steel (316), the belt is flexible enough to allow it to be sprung open or closed without the need for hinges, resulting in a very smooth profile. Tollyboy's locking system secures the waist band and crotch guard in one smooth joint, ensuring that the crotch guard remains vertical without any side to side swivel (a weakness in many competing designs).
Approximate weight: 1lb 10oz (0.73 Kg)
Supplied with two keys.
MB/200 Belt Set
This appliance uses the same waist band and crotch guard as the MB/100 but does not terminate in the twin chain 'Y' configuration. The guard is secured to the waist band at the rear by means of a solid stainless steel strap which is a snug fit between the buttocks. The anus as well as the vagina is protected and made inaccessible providing full protection. The appliance allows for urination only and does not facilitate defecation, the maximum period of wear is therefore limited to the period between bowel movements.
Supplied with two keys.
MGA/200 Belt Set
This chastity belt uses the same waist band and crotch guard as the MB/100 but does not terminate in the twin chain 'Y' configuration. The guard is secured to the waist band at the rear by means of a solid 4mm stainless steel cable which is a snug fit between the buttocks. The back strap is in the form of a round section stainless steel cable shaped to the body and curved to follow the contour up between the buttocks. The cable is plastic coated; although it is rigid the belt still retains flexibility where it matters. Due to its small diameter and plastic coating, the cable offers minimum obstruction to the passing of faeces, being soft they simply break up. Keeping the cable clean is a relatively easy task and maintaining hygiene is not a problem, however the use of a bidet is highly recommended but not essential. The cable will of course make entry to the anus difficult, no matter what position the wearer might adopt, but this will also depend on the individual's anatomy (i.e., relative size of the scrotum sack). The MGA/200 offers a number of advantages, lack of back straps passing over the buttocks presents a lower profile, so that the outline is virtually invisible under close fitting apparel. It is lighter in weight, and in some situations easier to wear than other belt sets. It has been subjected to long periods of wear and found to be completely effective and practical, however it is not suitable in every case because of individual anatomy.
Supplied with two keys.
Drop front Waistband
The Drop front Waistband is a new type of waistband offered on all Tollyboy belts. It offers more freedom of movement, especially when bending forward and is accommodating of the 'beer belly' . This waistband is designed to be more ergonomic, it drops at a 30 degree angle from the hips to the centre front. This makes it easy for the wearer to bend forwards. The waistband does not slope downwards at the back thus preventing pressure being applied above the sciatic nerve an occasional but real problem with some other ergonomic-design waistbands. The Drop front Waistband is the result of extensive research and testing and represents a very serious alternative to the standard models in terms of both security and long-term wearability.
Supplied with two keys.
|
