PRODUCTS INTERNATIONAL |
||
Female Belts Male Belts Accessories Restraints Jewellery Measurements Prices Contact Gallery Information Introduction Spare parts |
Guardian Body Armour |
|
MB/100 Belt Set
|
||
Click Photo Click Photo Click Photo Click Photo Click Photo
|
The standard male chastity belt follows a
traditional Florentine design. This consists of a waistband
(1.25'' wide and 0.64'' thick) with an attached crotch guard which is
closed and locked at the centre of the waist. The crotch guard
incorporates a penis sheath that, unlike other chastity belt
manufacturers, is made to the individual's precise measurements. This
is a separate component into which the penis is inserted, it is then
engaged internally into the crotch guard, which is then locked to the
waistband. The sheath is adjusted to its correct position externally
and then secured with a second locking system. In this belt the penis
is held pointing downwards and backwards between the legs, which
prevents an erection but allows the wearer to urinate without any
problem - except that he has to sit like a female. Once the sheath is
locked into position the penis cannot be handled. The crotch guard is
shaped and contoured to fit the genital area and stops just short of
the anus, where it terminates in two flat-section stainless steel
chains. To permit defecation these form a 'Y' configuration going
over the buttocks to the waist band, where they are riveted.
|
|
MGA/200 Belt Set
|
||
Click Photo |
This chastity belt uses the same waist band and crotch guard as the MB/100 but does not terminate in the twin chain 'Y' configuration. The guard is secured to the waist band at the rear by means of a solid 4mm stainless steel cable which is a snug fit between the buttocks. The back strap is in the form of a round section stainless steel cable shaped to the body and curved to follow the contour up between the buttocks. The cable is plastic coated; although it is rigid the belt still retains flexibility where it matters. Due to its small diameter and plastic coating, the cable offers minimum obstruction to the passing of faeces, being soft they simply break up. Keeping the cable clean is a relatively easy task and maintaining hygiene is not a problem, however the use of a bidet is highly recommended but not essential. The cable will of course make entry to the anus difficult, no matter what position the wearer might adopt, but this will also depend on the individual's anatomy (i.e., relative size of the scrotum sack). The MGA/200 offers a number of advantages, lack of back straps passing
over the buttocks presents a lower profile, so that the outline is
virtually invisible under close fitting apparel. It is lighter in
weight, and in some situations easier to wear than other belt sets. It
has been subjected to long periods of wear and found to be completely
effective and practical, however it is not suitable in every case
because of individual anatomy.
Approximate weight: 1lb 8oz (0.69 Kg) |
|
MB/100 and MGA/200 with Drop-Down Waistband
|
||
Click Photo |
The Drop-Down Waistband is a new type of waistband offered on all
Tollyboy belts. It offers more freedom of movement, especially
when bending forward and is accommodating of the 'beer belly' .
This waistband is designed to be more ergonomic, it drops at a 30 degree angle
from the hips to the centre front. This makes it easy for the wearer to bend forwards.
The waistband does not slope downwards at the back thus preventing pressure being applied
above the sciatic nerve an occasional but real problem with some other ergonomic-design waistbands.
The Drop-Down Waistband is the result of
extensive research and testing and represents a very serious
alternative to the standard models in terms of both security and
long-term wearability.
|
|
Many Tollyboy products are copied, but none equal our quality. |