|B||Waist controlled ( take a deep breath and pull in to make it as small as possible)|
|M||Waist measurement using one inch wide belt. Adjust the belt to the smallest circumference at which you feel you could wear it and mark the position. Do not be tempted to settle for a nice comfortable fit, aim at a tight rather than a loose fit. Remove the belt, lay it out flat and measure from the end to the reference mark to determine the length.The waistband will be made to this measurement. A and B are used to provide a comparative check.|
|N||Hips circumference. Hips must be bigger than waist if the belt is going to be secure or in some cases even possible.|
|Side Chain Length
With the belt still in position around the waist, make a mark on the thigh where the band is to fit or put another belt around one of the thighs at the desired position (6" above the knee is a typical choice, lower than this is not very practical).
Right Thigh Circumference
Measure around the thigh keeping the tape in close contact
Left Thigh Circumference
Measure both thighs in case there is significant difference between them
Veel Tollyboy producten worden gekopieerd, maar geen van allen zijn ze gelijk aan onze kwaliteit.